1. Can I disconnect cable from the lamp end to route it into a weatherproof box to meet up with camera cable? 2. This flood light splits the existing Cat5e or Cat6 to use for light and camera? Meaning no need to run additional Cat5e,6 for this light? 3. If I have a Cisco switch that supports 802.3at PoE+ and 802.3af can I run a Cat5e cable directly to this device or will I need another part to do it? 4. Can the unit be set to an "always on" mode? I would like to control the off/on by either simply plug/unplug on the injector. 5. I plan on using an IR illuminator for a Reolink RLC-410 camera with wavelength of 850nm. Will this flood light work, and if so, what is the approximate distance? 6. Are these flood lights 802.3af compliant? 7. Can you switch the light to dusk to dawn instead of motion? 8. Do I have to use the provided power supply if I have an 802.3af switch with the PL-PoE-IR-6w IR illuminator dusk to dawn with PoE pass thru? 9. Can I use this as a stand alone PoE motion detected spot light?